Menu
Book a Putter Fitting
What this drill trains
LineThe hole is the gate
SpeedDie pace, 10 ft
ReadRamp check
10 ft putt · no ball gate
The hole is the gate
On a straight 10 ft putt rolled at die pace, the hole allows 1.01° of start-line error. That is the same room for error as a narrow gate 5.2 mm either side of the ball at 30 cm, without a ball gate sitting in view at address.
Equipment required
- 1chalk line
- 1LSR ZERO·ZERO GATE / custom gate
- 1chalk pen
Set up
Step 1
Find a straight 10 ft puttRoll a few balls down a ramp to check it holds its line.
Step 2
Ping the chalk line12 ft back from the hole, through the centre of the cup.
Step 3
Mark the 90° at 10 ftUse the LSR ZERO·ZERO GATE to accurately mark a 90° line across the chalk line. This is where the putter face sets square.
Step 4
Mark the dotA small dot on the chalk line, 3 ft in front of the ball.
The drillMake a confident stroke and focus on rolling the ball over the dot 3 ft away. Free-flowing stroke, target-focused mindset.
Watch the drill ↓
The hole is the gate · dot 3 ft in front of the ball
LSR ZERO·ZERO GATE
LINE. SPEED. READ.
Same start-line feedback. Free flowing and target focused.
Coming soonMy blog
The AI Caddie
The AI Caddie
The art of reading greens – inside 10ft
The art of reading greens – inside 10ft
Lag Putting Midrange
